From: Troy C. <tr...@ca...> - 2008-09-11 13:23:01
|
On Thursday 11 September 2008 8:11:40 am Rick Bolen wrote: > Also... is the PLM transmitting to both X10 and PLM devices on your > house wiring? > > One hypothesis I have is that the PLM becomes "latched" switching > between the X10 xmitter and the Insteon xmitter (although I don't have a > schematic of the PLM nor its' firmware code). On occasion I've seen the > ~"PLM extreamely busy" message precede the freeze... and I don't have a > busy configuration at the moment, with only one insteon switch in the > mix w/~5 X10 switches. > > Lastly, the one time I had (intrusive) software serial monitoring in > place (my current sniffer config is non-intrusive), and experienced the > freeze, the PLM was returning a stream of 0xFC (or 0xF<something>). I > don't believe this stream appeared in the Insteon logging within MH. > > I'm in a much better position to capture what happens "on-the-wire" > now... if I could only repro. > The PLM physically says REV 2.75, firmware is .63 I do not use any Insteon devices other than the PLM. I've been thinking of replacing two LM14 modules with Insteon since the PLM can't due the extended code dim commands. I do have about 50 older X10-only Switchlincs (receive only), but this has only come up recently. I did have to shut down the Misterhouse server the other day, but I believe this problem was happening before that. |