Re: [misterhouse-users] Code_select.pl and authorization

[Timothy S. <spaulding@ICanBrew.com>]

one additional note that might help.

If I connect from an IP address that is not I the password_allow_client
config_parms, I am able to successfully log in as 'admin'.
----- Original Message ----- 
From: "Timothy Spaulding" <spaulding@ICanBrew.com>
To: <mis...@li...>
Sent: Monday, April 19, 2004 6:46 AM
Subject: RE: [misterhouse-users] Code_select.pl and authorization


When I try this, I always get "loged in as family", no matter what.

I do have a password set for both family and admin.

-----Original Message-----
From: mis...@li...
[mailto:mis...@li...] On Behalf Of
Bruce Winter
Sent: Sunday, April 18, 2004 3:12 PM
To: mis...@li...
Subject: RE: [misterhouse-users] Code_select.pl and authorization


Hmmm, when you click 'log in as admin', do you a web page that has this
on
it:

 admin password accepted

If not, what do you see?

Maybe you have not set the admin password?   Here are a few lines from
install.*:

To enabled password protection, run mh/bin/set_password command like
this:

 set_password -user family -password xyz1  set_password -user admin
-password xyz2

Note: only the first 8 characters are used.
The admin password is required for controling the mh web setup menus
(e.g.
item and code selection menus).

Bruce


-----Original Message-----

Hi All,

I have a memory that this was discussed before here, but I can't find it
presently.

I am wanting to enable some code in the common directory and I am using
the link http:localhost:8080/bin/code_select.pl to get to the page.

It shows all the check boxes as disabled and that I am logged in as
family.
I click to log in as admin, but it never does get me log in as admin.

My .ini file has the password_client=127.0.0.1 (and my local ip net, but
this doesn't help.

What do I need to do to get this to work properly?
!DSPAM:40802c6b152186458914238!



-------------------------------------------------------
This SF.Net email is sponsored by: IBM Linux Tutorials Free Linux
tutorial presented by Daniel Robbins, President and CEO of GenToo
technologies. Learn everything from fundamentals to system
administration.http://ads.osdn.com/?ad_id=1470&alloc_id=3638&op=click
________________________________________________________
To unsubscribe from this list, go to:
http://sourceforge.net/mail/?group_id=1365





-------------------------------------------------------
This SF.Net email is sponsored by: IBM Linux Tutorials
Free Linux tutorial presented by Daniel Robbins, President and CEO of
GenToo technologies. Learn everything from fundamentals to system
administration.http://ads.osdn.com/?ad_id70&alloc_id638&op=ick
________________________________________________________
To unsubscribe from this list, go to:
http://sourceforge.net/mail/?group_id65