From: JM M. <Jam...@so...> - 2001-05-28 14:40:01
|
Hi Kevin, I didn't have this url in my bookmark but now it is :)) There are lots of info and tips about x10 hardware, I think I can modify my new cm11 before overheating now. Many thanks Jean-Marie ----- Original Message ----- From: "Kevin Olalde" <ko...@ho...> To: <mis...@li...> Sent: Monday, May 28, 2001 4:12 PM Subject: Re: [misterhouse-users] CM11 overheating > There's some information at: > > http://www.geocities.com/ido_bartana/ > > There is a small modification that is described, but I've never had the > problem so I've never tried the modification. > > The halogen lamp correlation I remembered was most likely due to the > dimmers often built within. > > ko > > James Fox wrote: > > > > I've only add a new box running NT4 dedicated for mh > > and a new APC ups, CM11 is NOT plugged on the output of the ups. > > This new hardware worked for 3 days but now CM11 seems to be dead > > I've seen many posts in automations forum about 'cm11a overheating' but no > > one seems to have a > > solution to this problem. > > The first cm11a bought two years ago had exectly the same problem the first > > day I've plugged it !!! > > the vendor changed it rapidly but he said he have never seen this problem > > before !!! > > > > So all informations about 'overheating cm11a' are welcome before I'll buy a > > new one. > > > > Thanks again > > > > Jean-Marie Martin > > ----- Original Message ----- > > From: "Kevin Olalde" <ko...@ho...> > > To: <mis...@li...> > > Sent: Sunday, May 27, 2001 1:05 AM > > Subject: Re: [misterhouse-users] CM11 overheating > > > > > Have you recently plugged in a new appliance (like a halogen lamp)? I > > > seem to remember some correlation. > > > > > > Kevin > > > > > > > James Fox wrote: > > > > > > > > Hi All, > > > > My CM11A was working for 2 years but now it's overheating and not send > > > > or receive anything with mh :((( > > > > I've seen that this problem happened to few (many) ha users, is there > > > > a way to repair it ? or somrthing to do > > > > before overheating. X10 in europe is expensive ~= 100 usd for a cm11a > > > > working with 220v. > > > > I need a bidirectional interface, can I replace cm11a with other > > > > hardware ? > > > > > > > > Thank you > > > > Jean-Marie Martin > > > > > > ________________________________________________________ > > > To unsubscribe from this list, go to: > > http://sourceforge.net/mail/?group_id=1365 > > > > > > > > > > ________________________________________________________ > > To unsubscribe from this list, go to: http://sourceforge.net/mail/?group_id=1365 > > ________________________________________________________ > To unsubscribe from this list, go to: http://sourceforge.net/mail/?group_id=1365 > > |