Re: [Madwifi-users] IXP425 Platform - Frame Errors - No ping replied

[Edmond D. <edm...@gm...>]

Dear Sebastian,

thanks for replying.
I've tried this already sometimes, and now I tried again.
Deactivating WEP makes nothing better. The WEP key I tested sometimes 
converting it to hex and vice versa
- I'd say I'm sure the keys are the same, though you never could be sure 
they are, when it's not working.

But there was no positive effect.

Thank you very much even it didn't help:-(

Edmond


iwconfig ath0
ath0      IEEE 802.11b  ESSID:"Homezone"  Nickname:"intradisk"
          Mode:Managed  Frequency:2.442GHz  Access Point: 00:03:2F:0B:D2:4A
          Bit Rate:11Mb/s   Tx-Power:50 dBm   Sensitivity=0/3
          Retry:off   RTS thr:off   Fragment thr:off
          Encryption key:off
          Power Management:off
          Link Quality:33/94  Signal level:-62 dBm  Noise level:-95 dBm
          Rx invalid nwid:3748  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:0  Invalid misc:0   Missed beacon:0

# ifconfig
ath0      Link encap:Ethernet  HWaddr 00:05:4E:4A:D8:6C
          inet addr:192.168.0.2  Bcast:192.168.0.255  Mask:255.255.255.0
          UP BROADCAST RUNNING  MTU:1500  Metric:1
          RX packets:235 errors:538 dropped:0 overruns:0 frame:538
          TX packets:315 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:199
          RX bytes:10810 (10.5 kiB)  TX bytes:28878 (28.2 kiB)
          Interrupt:27 Memory:4bff0000-4c000000


Sebastian Weitzel wrote:

>> The problem is, that I'm not able to get the card transferring some 
>> data or pinging my accesspoint.
>> everything is running without problems doing the following steps:
>
>
> I guess there is a Problem with the wep encryption. Try to set the 
> exactly same
> hex key on the ap, or for testing you may just disable wep at all.
>
> Regards,
> Sebastian Weitzel
>
> ----------------------------------------------------------------
> This message was sent using IMP, the Internet Messaging Program.
>
>