Re: [Madwifi-users] Changing txpower has no effect.
Status: Beta
Brought to you by:
otaku
From: Leigh S. <st...@fl...> - 2004-05-19 16:18:48
|
> From: Sam Leffler <sa...@er...> > Subject: Re: [Madwifi-users] Changing txpower has no effect. > Date: Thu, 22 Apr 2004 17:47:11 -0700 > > The per-packet txpower value is used by the h/w to index into a table > from which the h/w settings are fetched to use in sending the frame. The > contents of this table is complicated to explain and not readily > accessible. However it is supposed to map txpower values in the range > [0-63] (6 bits) into equivalent output power for the frame (and yes I did > check it's contents before claiming TPC was "working"). > > I need to special-case a zero txpower setting to mean "turn off the radio". > Alternatively I guess I could simply discard packets in the driver if the > power is set to zero but that would be a hack. Hi Sam. Do you have an ETA for the above change (zero txpower)? If its going to take a while, I will go ahead and whack the driver to discard packets ... Thanks! Lbs ---------------------------------------- Leigh B. Stoller University of Utah - Flux Research Group http://www.cs.utah.edu/~stoller ---------------------------------------- |