From: Diego I. <ias...@ac...> - 2003-04-03 14:35:26
|
did that, now lircd starts.=20 however after i run irw, it dies and i need to delete /var/lock/subsys/lircd before runing this service again. no lirc :-( this is /etc/sysconfig/lircd/ [root@cucomania todos]# cat /etc/sysconfig/lircd # Customized setings for lirc daemon # The hardware driver to use, run lircd --driver=3D? for a list DRIVER=3Ddefault # Hardware driver module to load HWMOD=3DUNCONFIGURED # The device node that communicates with the IR device. # with devfs enabled DEVICE=3D/dev/lirc/0 #DEVICE=3D/dev/lirc/serial # without devfs #DEVICE=3D/dev/lirc # Serial port for the receiver (for serial driver) # COM1 (/dev/ttyS0) #COM_PORT=3D/dev/ttyS0 #DRIVER_OPTS=3D"irq=3D4 io=3D0x3f8" # COM2 (/dev/ttyS1) #COM_PORT=3D/dev/ttyS1 #DRIVER_OPTS=3D"irq=3D3 io=3D0x2f8" # COM3 (/dev/ttyS2) #COM_PORT=3D/dev/ttyS2 #DRIVER_OPTS=3D"irq=3D4 io=3D0x3e8 # COM4 (/dev/ttyS3) #COM_PORT=3D/dev/ttyS3 #DRIVER_OPTS=3D"irq=3D3 io=3D0x2e8" i mod probbed lirc_gpio before, starting lircd, here: [root@cucomania todos]# dmesg | grep lirc lirc_dev: IR Remote Control driver registered, at major 61 lirc_gpio (-1): card type 0x23, id 0x18501851 lirc_gpio (0): driver registered =D7=91=D7=99=D7=95=D7=9D =D7=A8=D7=91=D7=99=D7=A2=D7=99, 2 =D7=91=D7=90=D7= =A4=D7=A8=D7=99=D7=9C 2003, 18:10, Christoph Bartelmus =D7=9B=D7=AA=D7=91: > Hi! > > Diego Iastrubni "ias...@ac..." wrote: > > i was going to ask about the same question: > > madnarke 9.1 comes with a precompiled lirc, and while the kernel drivers > > they providde have support for FlyVideo the lircd does not have support > > for it. > > [...] > > >> Supported drivers: > >> default > >> creative > >> logitech > >> pinsys > >> pixelview > >> silitek > >> slinke > >> dsp > >> null > > The driver you have to use is "default". > > Christoph > > |