From: Jon S. <jon...@gm...> - 2010-07-31 14:38:01
|
On Sat, Jul 31, 2010 at 10:28 AM, Maxim Levitsky <max...@gm...> wrote: > On Sat, 2010-07-31 at 09:55 -0400, Andy Walls wrote: >> On Fri, 2010-07-30 at 15:45 +0300, Maxim Levitsky wrote: >> > On Fri, 2010-07-30 at 08:07 -0400, Jon Smirl wrote: >> > > On Fri, Jul 30, 2010 at 8:02 AM, Jon Smirl <jon...@gm...> wrote: >> > > > On Fri, Jul 30, 2010 at 7:54 AM, Maxim Levitsky <max...@gm...> wrote: >> >> > >> > > > >> > > > + pll_freq = (ene_hw_read_reg(dev, ENE_PLLFRH) << 4) + >> > > > + (ene_hw_read_reg(dev, ENE_PLLFRL) >> 2); >> > > >> > >> > >> > > I can understand the shift of the high bits, but that shift of the low >> > > bits is unlikely. A manual would tell us if it is right. >> > > >> > This shift is correct (according to datasheet, which contains mostly >> > useless info, but it does dociment this reg briefly.) >> >> The KB3700 series datasheet indicates that the value from ENE_PLLFRL >> should be shifted by >> 4 bits, not by >> 2. Of course, the KB3700 >> isn't the exact same chip. > You are right about that, thanks! I looked at KB3700 manual. It says it is trying to make a 32Mhz clock by multiplying 32.768Khz * 1000. 32,768 * 1000 = 32.768Mhz is a 2.4% error. When you are computing the timings of the pulses did you assume a 32Mhz clock? It looks like the clock is actuall 32.768Mhz. > > Best regards, > Maxim Levitsky > > -- Jon Smirl jon...@gm... |