Re: PVR150 IR Blaster

[RoyalPro <eri...@gm...>]

In hardware.conf after changing to MODULES="lirc_dev lirc_i2c lirc_pvr150" my
remote stopped working even as it did before. I then tried with
MODULES="lirc_i2c lirc_pvr150" and still nothing. Then I tried
MODULES="lirc_pvr150 lirc_i2c" to see if the order had anything to do with
it it and it does. Now my remote works like it used to and the light on the
blaster is now flashing when I do a
Code:

eric@umc:~$ irsend SEND_ONCE blaster RED

with no errors.  Hope this helps others.


RoyalPro wrote:
> 
> I am using Ubuntu  Gutsy kernel version 2.6.22-14-generic.  I have
> lirc-0.8.3-CVS-pvr150.tar.bz2 installed (I think).  I had to install the
> Ubuntu version first then the 8.3 version to get the remote to work.  I
> have the firmware haup-ir-blaster.bin in /lib/firmware/2.6.22-14-generic. 
> I have add to my lircd.conf
>  begin remote:
>   name          blaster
>   bits          32
>   flags         RAW_CODES
>   eps           0
>   aeps          0
>   plead         0
>   gap           333333
>   repeat_bit    0
>   begin raw_codes
>   name RED
>   1048586
>  end raw_codes
> end remote
> When I try and test it with irsend,I get the errors below.
> 
> eric@umc:~$ irsend SEND_ONCE blaster RED
> irsend: command failed: SEND_ONCE blaster RED
> irsend: hardware does not support sending
> 
> eric@umc:~$ irsend SEND_ONCE blaster POWER
> irsend: command failed: SEND_ONCE blaster POWER
> irsend: hardware does not support sending
> 
> Any help would be great and if you need any more info let me know.
> 

-- 
View this message in context: http://www.nabble.com/PVR150-IR-Blaster-tf4627229.html#a13329170
Sent from the LIRC mailing list archive at Nabble.com.