From: Eric W. <wes...@ea...> - 2006-08-09 00:07:04
|
If I use the standard creative remote config I can operate my remote. However I'd like to use a different remote so I fire up irrecord -d /dev/ttyS0 newconf.conf When it asks to hold down any button the respond is irrecord: unknown code Now, I even tried using irrecord with the offical creative remote (the same one the conf comes for w/ lirc) and I get the same messages. I've tried adjusting the baud rate on the serial port with no luck. However if I set it to 9600 instead of irrecord: unknown code I now get irrecord: bad envelope. Is there any other method I can obtain the correct codes for my remote w/o using irrecord? I can cat /dev/ttyS0 and see output. Is there any way I can simply use this data? Thanks Eric |