From: Michael B. <mi...@bu...> - 2004-12-29 02:10:47
|
Hi everybody, I'm reposting my previous question because, well, I'm still pretty much stuck. Can anybody tell me if the hardware I'm using is actually supported by the mp3anywhere driver and if the configuration I've outlined below is correct? Can anyone suggest what I should try next to figure out the problem? Some additional information: The "bad envelope" errors appear as soon as irw is run, not when buttons on the remote are pressed. Any suggestions greatly appreciated, Mike > Hi, > > I'm having some trouble getting lirc to work with with the x10 MR26A RF > receiver and UR51A remote. This model looks like it is supported by the > mp3anywhere driver. Is this correct? > > I'm using the latest CVS sources and building against FC3 kernel > 2.6.9-1.681_FC3 > > Configuration, building and installation all work fine. I select the > mp3anywhere driver on ttyS0 in setup.sh. Here's the configure line from > the log: > > ./configure --with-moduledir=/lib/modules/2.6.9-1.681_FC3/misc > --with-tty=/dev/ttyS0 --with-x --with-driver=mp3anywhere --with-major=61 > --with-port=none --with-irq=none > > I also added the following to /etc/modprobe.conf: > > # lirc: > alias char-major-61 lirc_serial > install lirc_serial setserial /dev/ttyS0 uart none; \ > /sbin/modprobe --ignore-install lirc_serial > > and put /usr/local/lib in /etc/ld.so.conf. > > When I run lircd and irw (in another window), here's what I see: > lircd 0.7.1-CVS: lircd(mp3anywhere) ready > lircd 0.7.1-CVS: accepted new client on /dev/lircd > lircd 0.7.1-CVS: bad envelope > lircd 0.7.1-CVS: bad envelope > lircd 0.7.1-CVS: bad envelope > > And no button presses register in irw. > > I'm stuck at this point. Any help would be greatly appreciated. > > Thanks, > Mike > -- Michael Buksas -- mb...@bu... -- www.buksas.net |