From: Roeland M. <roe...@te...> - 2004-09-20 09:44:50
|
On Mon, Sep 20, 2004 at 11:35:13AM +0200, Alien wrote: > -----BEGIN PGP SIGNED MESSAGE----- > Hash: SHA1 > > Op maandag 20 september 2004 10:56, schreef Roeland Moors: > > On Mon, Sep 20, 2004 at 09:15:27AM +0200, Alien wrote: > > > -----BEGIN PGP SIGNED MESSAGE----- > > > Hash: SHA1 > > > > > > Op maandag 20 september 2004 01:56, schreef u: > > > > On Mon, Sep 20, 2004 at 01:38:03AM +0200, Alien wrote: > > > > > Op maandag 20 september 2004 01:13, schreef Jonas H.: > > > > > > I have modprobed lirc_dev and lirc_gpio, ran lircd --nodaemon and > > > > > > irw. > > > > > > > > > > > > Pointing the remote at the reciever, pressing buttons and.... > > > > > > > > > > > > Nothing. > > > > > > > > > > > > I am a bit at a loss of where to go from here. Any pointers? > > > > > > > > > > > > Tried loading the lirc_gpio module with the parameters > > > > > > gpio_mask=0xf88000, gpio_lock_mask=0x10000, gpio_xor_mask=0x10000, > > > > > > soft_gap=0, sample_rate=10 as mentioned on > > > > > > http://www.lirc.org/html/install.html#specific - didn't change > > > > > > anything. > > > > > > > > > > i have somewhat same problem as you (again): > > > > > tried mode2 , pressed buttons and ... nothing... > > > > > > > > Well, I take it you're using a serial reciever or something like that, > > > > since you're using mode2? Mine doesn't work with mode2 because it's not > > > > a pulse/space thing. So I doubt these problems are comparable :) > > > > > > whoops: i thought that was for all things, i'm using a remote with a > > > TVCard... > > > > > > how do i know what to do? how do i test it out? > > > > I don't think mode2 works with a tv card. Try using irrecord. > > well, i did, it asked me to press a button, but dots kept appearing and it > stopped after a while, then it asked for the name of the next button, so i > typed it in, and then when it asked to press a button, i was too late, it > asked one second, and just continued, i don't think it reacts to pressing > buttons... > When irrecord starts, you have to hold a button down for a while. Then you can start defining buttons. First you enter the name of a button and then you have to press the button once. This should create a lircd.conf file. I only used it once so I might be wrong here. -- Roeland |