[jOrgan-user] Jorgan and Stop tabs Real and Virtual

[George A <gat...@op...>]

Hello Everyone,

I'm hoping some of you can give me an inkling into what is happening with my
Jorgan 3 setup.  I am cross posting this letter in the hopes that I'll find
the answers quicker.  Thanks for your understanding.  The problems are as
following:  

1.  A stop that will record a "Deactivate" command but will not record a
"Activate" command.

2.  A stop in one division will cause some other stop tab in a different
division to momentarily flicker down and up. 
     This occurs when the oncscreen Jorgan stop tab is flipped.  

3.  When turning one stop tab on by means of the console, two stop tabs sill
show up depressed on the Jorgan      screen. Even though only the original
depressed stop tab has Activate and Deactivate messages recorded..

4.  Some stop tabs will not record either an Activate or Deactivate message. 
Even though the SAM unit checks out      OK and the associated reed swith is
working properly.  

5.  Of the 10 trems I have on the console, only one is working properly.  In
addition there are other message entries      for each TREM tab besides the
standard Activate and Deactivate messages.  could some one tell me which          
entries should or should not be there?

I thank everyone who can give some input on these matters and I send my Best
Regards to All.

George
-- 
View this message in context: http://www.nabble.com/Jorgan-and-Stop-tabs-Real-and-Virtual-tp18790579p18790579.html
Sent from the jOrgan - User mailing list archive at Nabble.com.