[Hamlib-developer] rpcrig get level (STRENGTH) vs TS-2000 backend

[Patrick O. <pa...@fl...>]

Hello Hamlib Developers,

I'm trying to find the place where the rpcrig calls the get_level
procedure to get the S-meter reading.  I have a Kenwood TS-2000 and a
Yaesu FT-817.

When I use "rigctl -m 120" or "rigctl -m 214" (FT-817 or TS-2000) and
check the S meter reading with "l STRENGTH" I get reasonable values
(negative numbers for below S9).

When I run the rpc.rigd on either rig, then run "rigctl -m 1901" and
check the S-meter value, it is always a positive number.  Is the the
expected behavior?  If not, any suggestion on where to look in the code
to fix it?

Thanks,

Pat

-- 

Patrick Ouellette                 pa...@fl...
kb...@ar...                   Amateur Radio: KB8PYM 
Living life to a Jimmy Buffett soundtrack
"Crank the amp to 11, this needs more cowbell - and a llama wouldn't hurt either"