From: Derek N. <der...@gm...> - 2010-09-16 21:46:51
|
Can I register an IRQ with any GPIO line? Are there specific GPIO pins that are set up to be an IRQ that I should be using? I am a hardware guy so I'm not very familiar with the kernel. I am trying to find a gpio line that I can connect to a supervisor chip that will tell the gumstix to shutdown when the board is losing power. I was looking at the post below, but couldn't figure out if I should be using a specific gpio pin as an interrupt or if I can just choose any line I want that isn't being used. http://old.nabble.com/GPIO-IRQs-in-kernel-for-Overo-td21890338.html Thanks for your help, Derek |