[Gumstix-users] New Robostix not recognized (after modifications)

[VaibhavGhadiok <vai...@gm...>]

hi

I have a verdexpro attached with a netpro-vx and robostix. All thee boards
are new. When I try to do a uisp I get a  message stating 

Cannot identify device because it is locked.
Device similar to the ATMEGA103-old is found.
Device is locked.
Address out of memory range.

I have made the necessary modifications to the robostix.

1. The resistor pulling the RX pin high.
2. two pull ups for i2c
3. Power Modification as per robostix.pdf. (The entire one side of the IC is
shorted when I short two pins on it)
4. Jumpers for programming

With regards
Vaibhav

-- 
View this message in context: http://old.nabble.com/New-Robostix-not-recognized-%28after-modifications%29-tp26616171p26616171.html
Sent from the Gumstix mailing list archive at Nabble.com.