From: Wenjia L. <we...@mt...> - 2009-05-20 15:38:54
|
Hello, I am mad on my wifistix after dozens of hours... With the wifi, i revised the /etc/network/interfaces like this: auto lo iface lo inet loopback iface bnep0 inet dhcp auto mwlan0 iface mwlan0 inet static pre-up /sbin/iwconfig $IFACE essid test txpower 100mW address 192.168.1.55 netmask 255.255.255.0 gateway 192.168.1.1 And when i use iwconfig, it says: # iwconfig lo no wireless extensions. mwlan0 MRVL-CF8385 ESSID:"test" Nickname:"" Mode:Managed Frequency:2.437 GHz Access Point: 00:1D:7E:18:98:C8 Bit Rate:1 Mb/s Tx-Power=13 dBm Retry limit:8 RTS thr=2347 B Fragment thr=2346 B Encryption key:off Power Management:off Link Quality:0/10 Signal level:-39 dBm Noise level:-97 dBm Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:3032 Tx excessive retries:0 Invalid misc:0 Missed beacon:0 I can't ssh log into this gumstix... With the CF card, I revised /etc/module like below: # Compact Flash support -- Must load smc91x first!! smc91x pcmcia # proc gpio proc-gpio # i2c modules i2c-dev i2c-pxa # Load USB host driver #ohci-hcd #Driver for robostix control robostix_drv When I input df, there is no CF displayed... I feel so frustrated, could anyone give me some information? Thanks! |