From: Harry J M. <hj...@ec...> - 2008-08-04 10:01:55
|
On Mon, 4 Aug 2008, Dave Hylands wrote: >> 3. Is two wire I2C fine? As in, just using SDA and SCL? > > No - you also need a common ground. > >> 4. Dave's code is set to the /dev/i2c-0 device. Could it be possible that >> I somehow need the i2c-1 device, or is this not used? > > i2c-1 is for communicating with the PMU chip on the verdex. i2c-0 is > for the bus brought out on the hirose connector. Which bus is connected to the tsc2003 on the consoleLCD-16? When I boot my Verdex it only creates /dev/i2c-1 and not /dev/i2c-0. This might be a problem with my 2.6.26 patches--and would explain why X is unhappy with me. >> 2. Will both lines need the pull up resistors (I've tried with and without >> 4.3k resistors)? > > Yes. If the tsc2003 is on /dev/i2c-0, will I need to add these resistors? -- | Harry Mason | .------------. | .___, |"Whatever you do will be | | University of | | hjm200 @ | | ___('v')___ | insignificant. However, | | Southampton | | zepler.net | | `"-\._./-"' | it is vitally important | | England | '------------' | hjm ^ ^ | that you do it." Gandhi | |