From: Brian W. <bw...@ir...> - 2006-12-06 20:20:04
|
I am adding a button to be able to enter low power mode (umount CF, disable ethernet, turnoff LCD, etc) I am using the Connex 400 XM board + NetCF + breakout GS. If I understand correctly, I should be able to use GPIO 42 (BTUART) as my input with: echo "GPIO out clear" > /proc/gpio/GPIO42 and then controlling events via the gpip event montior. Is this correct? Also, Is there an easier/better pin to use? IE can I more easily use the pads on from the breakout GS (I2C/PWM) as my GPIO? I am a bit confused on this point. Thanks Brian |