From: Matthew S. <ma...@ec...> - 2006-04-22 21:44:19
|
Eric M wrote: > Hi guys, > > Just a quick questions: my robostix board seems to keep restarting > itself whenever I've got it plugged into a battery pack. I have the I2C > bootloader on it, loaded with a simple LED flasher program. > > The problem does not affect the board when it is plugged into an outlet > though. Now this could be a simple battery power issue, but the > confusing part is the battery has enough power to run a wifi card I have > plugged into the CFstix expansion. The robostix shouldn't draw that > much power, should it? Also, it's just the robostix that restarts, the > Gumstix stays fine...it's a conundrum... > > Thanks, > > Eric Check as the gumstix runs at 3.3V (as might your wifi card) while the robostix runs at 5v so the robostix may have built in supply health checks (brownout detection) which is resetting it as you are on the edge of its operating range. (at least that is what I would examine if I was using Microchip PIC microcontrollers) M -- Matthew Swabey Rm7025, Bldg21 Faraday Tower Department of ECS University of Southampton University Road Southampton, SO17 1BJ England Tel: 02380 597381 Mob: 07966 440946 |