[Gumstix-users] Re: Robostix TH header holes

[Rick <rick@LlamaTrails.com>]

Dave Hylands <dhylands <at> gmail.com> writes:

> 
> Hi Rick,
> > Concerning the connector header holes, the wiki specs page refers to Mouser
 page 908 for female headers.
> > What is the hole diameter ?
> > I would like to use the single row low profile ones that have a pin diameter
of .025" .
> 
> The headers on my robostix are 0.025" square. I don't know about the
> hole diameter.
> 
> --
> Dave Hylands

Dave,
     Thanks for the answer.  The referenced Mouser page shows both .016" and .025".

     If your header pins are .025" then that will work for the low profile
sockets, too.

Rick