[fuse-devel] Compiling FUSE for 32 bit system.

[rbhunia1234 <rbh...@gm...>]

Hi All,

I am working with a system where uClibc is not compiled with
__UCLIBC_HAS_LFS__ option.
When I am compiling fuse I am getting the following error:

#error It appears you have defined _FILE_OFFSET_BITS=64.  Unfortunately,
uClibc was built without large file support enabled.

Then I changed the Makefile of fuse and build it again without
-D_FILE_OFFSET_BITS=64 option. This time I got the following error:

#error Please add -D_FILE_OFFSET_BITS=64 to your compile flags!

Then I went through the code a little and found the following code in
include/fuse_common.h:

#if _FILE_OFFSET_BITS != 64
#error Please add -D_FILE_OFFSET_BITS=64 to your compile flags!
#endif

Then I commented that portion of code and tried to compile it again. This
time it was compiled successfully. But when i tried to run it in the system
it was crashing because of segmentation fault.

I am using fuse-2.5.3. It seems that it is not possible to use fuse without
_FILE_OFFSET_BITS = 64 option set. But I have to use a uClibc that is not
compiled with large file support. Is there any version of FUSE that does not
require large file support ?

Thanks in advance.

Thanks & regards,
Rakhahari Bhunia
-- 
View this message in context: http://www.nabble.com/Compiling-FUSE-for-32-bit-system.-tp16297085p16297085.html
Sent from the Fuse - Dev mailing list archive at Nabble.com.