From: James C. <jam...@in...> - 2006-07-07 15:51:42
|
=20 =20 Regards, James Cassidy =20 Software Engineer Intelliden, Inc http://www.intelliden.com <http://www.intelliden.com/>=20 Office: +442890930070 Internal IP Ext: 317 _______________________________________________________________________ This electronic message transmission, including any attachments, contains information from Intelliden, Inc., which may be confidential and/or privileged. The information is for the sole use of the intended recipient(s). If you are not the intended recipient, be aware that any disclosure, copying, distribution or use of the contents of this information is prohibited, please notify the sender immediately by a "reply to sender only" message and immediately destroy all electronic and hard copies of the ________________________________ From: James Cassidy=20 Sent: 07 July 2006 16:45 To: 'lex...@li...' Subject: Fex 'make' errors =20 Hi I have installed the gcc and now I am trying to install flex but I get an error. =20 =20 When I run './configure' it is fine, but when I run 'make' the following error occurs: =20 ************************************************************************ ************************************************************************ ************************************** bash-2.03# make make all-recursive Making all in . if gcc -DHAVE_CONFIG_H -I. -I. -I. -DLOCALEDIR=3D\"/usr/local/share/locale\" -I/usr/local/include -I./intl -I/usr/local/include -g -O2 -MT filter.o -MD -MP -MF ".deps/filter.Tpo" \ -c -o filter.o `test -f 'filter.c' || echo './'`filter.c; \ then mv ".deps/filter.Tpo" ".deps/filter.Po"; \ else rm -f ".deps/filter.Tpo"; exit 1; \ fi filter.c: In function `filter_apply_chain': filter.c:161: error: invalid lvalue in assignment filter.c:163: error: invalid lvalue in assignment filter.c:184: error: invalid lvalue in assignment *** Error code 1 make: Fatal error: Command failed for target `filter.o' Current working directory /opt/source/flex/flex-2.5.31 *** Error code 1 make: Fatal error: Command failed for target `all-recursive' Current working directory /opt/source/flex/flex-2.5.31 *** Error code 1 make: Fatal error: Command failed for target `all' =20 ************************************************************************ ************************************************************************ ************************************** =20 Can you tell me how I can overcome this problem, thanks in advance! =20 =20 Regards, James Cassidy =20 Software Engineer Intelliden, Inc http://www.intelliden.com <http://www.intelliden.com/>=20 Internal IP Ext: 317 _______________________________________________________________________ This electronic message transmission, including any attachments, contains information from Intelliden, Inc., which may be confidential and/or privileged. The information is for the sole use of the intended recipient(s). If you are not the intended recipient, be aware that any disclosure, copying, distribution or use of the contents of this information is prohibited, please notify the sender immediately by a "reply to sender only" message and immediately destroy all electronic and hard copies of the =20 |