From: John T. <cv...@cv...> - 2008-08-30 14:14:00
|
Modified file emc2/docs/src/gcode/main.lyx Full file: <http://cvs.linuxcnc.org/cvs/emc2/docs/src/gcode/main.lyx?rev=1.45.2.19> Difference: <http://cvs.linuxcnc.org/cvs/emc2/docs/src/gcode/main.lyx.diff?r1=1.45.2.18;r2=1.45.2.19> Branch: v2_2_branch Log: revision 1.45.2.19 date: 2008/08/30 14:13:57; author: bigjohnt; state: Exp; lines: +185 -515 some index work --- main.lyx 2008/08/24 14:21:17 1.45.2.18 +++ main.lyx 2008/08/30 14:13:57 1.45.2.19 @@ -1724,7 +1724,7 @@ \layout Section Comments -\begin_inset LatexCommand \index{comment} +\begin_inset LatexCommand \index{G Code Comments} \end_inset @@ -1760,7 +1760,7 @@ \layout Section Messages -\begin_inset LatexCommand \index{Messages} +\begin_inset LatexCommand \index{G Code Messages} \end_inset @@ -1831,8 +1831,8 @@ Using general logging, the format of the output data can be controlled. \layout Section -Debugging messages -\begin_inset LatexCommand \index{Debug} +Debugging Messages +\begin_inset LatexCommand \index{G Code Debugging Messages} \end_inset @@ -2567,6 +2567,11 @@ \layout Chapter Order of Execution +\begin_inset LatexCommand \index{G Code Order of Execution} + +\end_inset + + \begin_inset LatexCommand \label{sec:Order-of-Execution} \end_inset @@ -2654,7 +2659,12 @@ stop (M0, M1, M2, M30, M60). \layout Chapter -G-Code Best Practices +G Code Best Practices +\begin_inset LatexCommand \index{G Code Best Practices} + +\end_inset + + \layout Section Use an appropriate decimal precision @@ -2769,6 +2779,11 @@ \layout Chapter G Codes +\begin_inset LatexCommand \index{G Codes} + +\end_inset + + \layout Standard G codes of the RS274/NGC language are shown in Table 5 and described following @@ -2926,6 +2941,11 @@ \layout Section Quick Reference Table +\begin_inset LatexCommand \index{G Code Table} + +\end_inset + + \layout Standard @@ -4698,12 +4718,12 @@ \layout Section \pagebreak_top -G0 -\begin_inset LatexCommand \index{G0} +G0 Rapid Linear Motion +\begin_inset LatexCommand \index{G0 Rapid Linear Motion} \end_inset -: Rapid Linear Motion + \begin_inset LatexCommand \label{sec:G0:-Rapid-Linear} \end_inset |