[Alsa-user] Recording with a Midiman Audiophile

[Frank B. <bar...@ph...>]

Hi,

I just got my new Midiman Audiophile card and installed 0.9.0beta7. The
card plays fine but I have problems recording. 
"arecord -f cd -t wav -d 5 test.wav" just gives me a junk file full of
noise. I have no ~/.asoundrc and "arecord -l" gives:

card 0: card0 [M Audio Audiophile 24/96], device 0: ICE1712 multi [ICE1712 multi]
  Subdevices: 1/1
  Subdevice #0: subdevice #0
card 1: card1 [Sound Blaster Live!], device 0: emu10k1 [EMU10K1]
  Subdevices: 1/1
  Subdevice #0: subdevice #0
card 1: card1 [Sound Blaster Live!], device 1: emu10k1 mic [EMU10K1 MIC]
  Subdevices: 1/1
  Subdevice #0: subdevice #0
card 1: card1 [Sound Blaster Live!], device 2: emu10k1 efx [EMU10K1 EFX]
  Subdevices: 1/1
  Subdevice #0: subdevice #0

Next try was: 
$  arecord -f cd -t wav -d 5 -D hw:0 senso.wav
Recording WAVE 'senso.wav' : Signed 16 bit Little Endian, Rate 44100 Hz, Stereo
arecord: set_params:719: Sample format non available

and

$ arecord -f dat -t wav -d 5 -D hw:0 senso.wav 
Recording WAVE 'senso.wav' : Signed 16 bit Little Endian, Rate 48000 Hz, Stereo
arecord: set_params:719: Sample format non available

So how do I record with the Audiophile? 


And I found, that if I listen to the input signal of the Analog In via
Analog Out, the sound sounds low pass filtered, if I select Internel
Crystal as the master clock. If I select S/PDIF in instead, the sound
is okay. But I don't have anything connected to the S/PDIFs. Why's that
happening?

bye,
-- 
                                                 __    __
 Frank Barknecht       ____ ______   ____ __ trip\ \  / /wire ______
                      / __// __  /__/ __// // __  \ \/ /  __ \\  ___\	
                     / /  / ____/  / /  / // ____// /\ \\  ___\\____ \	
                    /_/  /_____/  /_/  /_//_____// /  \ \\_____\\_____\
                                                /_/    \_\