[Acx100-devel] Driver doesn't seem to work anymore

[Ismail D. <is...@ul...>]

Hi,

I tried the latest snapshot ( 20060117 ) and it seems no longer works. 
Attached syslog with debug=0xffff . Looks like driver tries to authenticate 
though I don't use a WEP key. Here is the commands I use :

southpark ~ # iwconfig wlan0 essid pardus
southpark ~ # ifconfig wlan0 192.168.3.250 up

acx driver shows :

wlan0     IEEE 802.11b+/g+  ESSID:"pardus"  Nickname:"acx v0.3.29"
          Mode:Managed  Frequency:2.437 GHz  Access Point: 00:00:00:00:00:00
          Bit Rate:1 Mb/s   Tx-Power=15 dBm   Sensitivity=0/3
          Retry min limit:7   RTS thr:off
          Encryption key:off
          Power Management:off
          Link Quality=38/100  Signal level=13/100  Noise level=0/100
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:0  Invalid misc:0   Missed beacon:0

Same time ipw2200 driver with same settings show:

eth1      IEEE 802.11g  ESSID:"pardus"
          Mode:Managed  Frequency:2.437 GHz  Access Point: 00:13:46:63:F2:CD
          Bit Rate=54 Mb/s   Tx-Power=20 dBm
          Retry limit:7   RTS thr:off   Fragment thr:off
          Encryption key:off
          Power Management:off
          Link Quality=89/100  Signal level=-33 dBm  Noise level=-81 dBm
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:0  Invalid misc:15   Missed beacon:14

I am 1 meter away from the AP, so I don't think its a problem.

Regards,
ismail