Morris Wideman

I am seeing this happen on JTDX, WSJTXIMPROVED and WS all the latest version of each. If the tuner is activated and I change TX freq within any band say moving from 500hz to 1500hz the tuner will deactavate or change again and tuner activates. The same behavior is happening to the split freq function VFO is being switched between A & B same time tuner is being switched on and off. I tried changing bands from HRD and not seeing this happen. My setup is FTDX 5000, HRD computer is HB AMD proc windows...

I have tried several of the older versions all did the same thing except for version 260418 it seems to run OK on FT4 mode the decode does not hang. 73 Morris WA4MIT

When ever I try to use FT4 mode the decode button will stay on permanately after 3 decode sequencies no further decodes are possible at this point. FT8 operation is normal this seems to only happen on FT4 mode. I have restarted my computer same results. Using latest download 260908. See attached screen shot

OK here is another update I deleted the wsjtx.adi file program ran normaly and I made one contact and it was shown in the adi file. I copied all my old contacts and pasted them into this new one contact file. Started wsjtx again and it imediately closed leaving the same orphaned file. 73 WA4MIT

I have tried to find what is causing my problem first thing is this file is being left running in system after improved is shut down see attached. I renamed wsjtx folder in the local folder and on the C drive to start a clean install this got the program to run and stay open. At this point I started to add into this new install some files from old wsjtx (local) I have found that adding the wsjtx.adi file that program will not stay on and it orphans the same file remove it and it stays on. 73 Morris...

Hello on my windows 11 fully updated computer I cannot run WSJTX IMPROVED and I cannot update software. If I try to use improved it opens and immediately shutsdown I read about others having this issue so I installed the trial version but it would not install see attached I then tried to reinstall .418 and it does same even tried a older version of wsjtx and same. I was able to install MSHV without any issue I can use JTDX along with HRD 6.9 and JTAlert. I had in past been using improved without...

Hello I am not able to use the newest software with the FT2 mode I have tried two different versions of improved and neither will connect to HRD nor my FTDX 5000. I initially renamed the exisiting WSJT-Xfolder in Local to try a raw new install after no radio connection I tried the install with the original WSJT-X folder but this did not help either. I also tried reverting to Hamlib 4.6 then tried updating and neither of these did not help. I can see decodes the audio is connecting but not radio....

If CQ/73 is checked when program is started it will not decode any FT4 signal. In version 240814 CQ/73 was not a sticky in version 241014 RC7 it became a sticky and this seems to be when this problem started. It is repeatable. FT8 works normally no problems seen. Uncheck CQ/73 box and decoding starts but sometimes when starting this way the decode hangs and decode light stays on. Shutting software down restarting decodes resume but may hang again. Starting with CQ/73 unchecked I have not seen any...