safi58

Hello, Thanks for your reply. Is there any way to align both of them from 0 without exporting to csv? Regards, Safi

Hi Davis, Can you also please tell me is this the correct way of calculating load at one point of time? say at 12pm the load profile is given 2pu and kw=100. Then the load is 200kw at 12pm. is this right? your help will be much appreciated. thanks,

Hi Davis, thanks for your reply. my code is bellow: Clear Set DefaultBaseFrequency=50 ! Source definition New object=circuit.WNM2A ~ basekv=11 pu=1.0 MVAsc3=100 MVAsc1=10 ! Load Transformer New Transformer.XFM1 Phases=3 Windings=2 Xhl=4.07 ~ wdg=1 Bus=sourcebus conn=Delta kv=11 kva=200 %r=0.37 ~ wdg=2 Bus=SP494119.1.2.3.0 conn=wye kv=0.406 kva=200 %r=0.37 !Conductor Codes New linecode.95ABC nphases=4 BaseFreq=50 units=km !95mm ABC XLPE conductors ~ rmatrix=[0.375748020 0.049348020 0.049348020 0.049348020...

Hi Davis, thanks for your reply. my code is bellow: Clear Set DefaultBaseFrequency=50 ! Source definition New object=circuit.WNM2A ~ basekv=11 pu=1.0 MVAsc3=100 MVAsc1=10 ! Load Transformer New Transformer.XFM1 Phases=3 Windings=2 Xhl=4.07 ~ wdg=1 Bus=sourcebus conn=Delta kv=11 kva=200 %r=0.37 ~ wdg=2 Bus=SP494119.1.2.3.0 conn=wye kv=0.406 kva=200 %r=0.37 !Conductor Codes New linecode.95ABC nphases=4 BaseFreq=50 units=km !95mm ABC XLPE conductors ~ rmatrix=[0.375748020 0.049348020 0.049348020 0.049348020...

here is the load profile. Can anyone please help?

here is the load profile

Hello, I included a load profile when I was doing load flow analysis. The issue is transformer power is similar to the load profile but there is a 1-hour difference between these two graphs. please see the attached graphs. Can anyone please tell me how can I make these on same starting point?!

Hi, How can I model this imperial conductor as underground cable? 0.1 Cu 4C - PLYSWS