Richa Priyadarshi

Dear sir, 1) is file: "Storage_123_RPD.dss" right way to initialize a battery inverter in an IEEE-123 bus system, such that bus 68 and 100 have 1-ф load and bus 76 has 3-ф spot loads. 2) When performing time-series analysis, in order to obtain voltage and power profiles, how to call the readings of monitor for bus 76, if file: "TimeSeriesAnalysis.m" shows the same for bus 68? 3) Is file: "Monitors_123" right way to place monitors?

Dear sir, 1) is file: "Storage_123_RPD.dss" right way to initialize a battery inverter in an IEEE-123 bus system, such that bus 68 and 100 have 1-ф load and bus 76 has 3-ф spot loads. 2) When performing time-series analysis, in order to obtain voltage and power profiles, how to call the readings of monitor for bus 76, if file: "TimeSeriesAnalysis.m" shows the same for bus 68? 3) Is file: "Monitors_123" right way to place monitors?

Dear sir, 1) is file: "Storage_123_RPD.dss" right way to initialize a battery inverter in an IEEE-123 bus system, such that bus 68 and 100 have 1-ф load and bus 76 has 3-ф spot loads. 2) When performing time-series analysis, in order to obtain voltage and power profiles, how to call the readings of monitor for bus 76, if file: "TimeSeriesAnalysis.m" shows the same for bus 68? 3) Is file: "Monitors_123" right way to place monitors?

Dear sir, 1) is file: "Storage_123_RPD.dss" right way to initialize a battery inverter in an IEEE-123 bus system, such that bus 68 and 100 have 1-ф load and bus 76 has 3-ф spot loads. 2) When performing time-series analysis, in order to obtain voltage and power profiles, how to call the readings of monitor for bus 76, if file: "TimeSeriesAnalysis.m" shows the same for bus 68? 3) Is file: "Monitors_123" right way to place monitors?

Dear sir, 1) is file: "Storage_123_RPD.dss" right way to initialize a battery inverter in an IEEE-123 bus system, such that bus 68 and 100 have 1-ф load and bus 76 has 3-ф spot loads. 2) When performing time-series analysis, in order to obtain voltage and power profiles, how to call the readings of monitor for bus 76, if file: "TimeSeriesAnalysis.m" shows the same for bus 68? 3) Is file: "Monitors_123" right way to place monitors?

Dear sir, Yes I have used Volt_var control mode. Used GridPV toolbox. Here is my Volt_VAr PV placement file.

Dear sir, I needed further help with my IEEE-123 sys. Sir, when observing feeder end voltages I see that without PV, there's voltage violation of (+-)5% (check IMG_1) , but when I have put PVs, there is instead undervoltage i.e. no violation. (check IMG_2) How do I rectify this? where am I going wrong? PS: I have tried changing various loadshapes. (I have also attached solar profile, and Loadshape used)

Dear sir, I have 3 doubts. 1) Sir as I see in IEEE-123 node test feeder letterhead (file I have attached) the specification for both substation and distribution transformers are given (see IMG_1). Somehow the master file given in IEEE test cases section for IEEE-123 dist. sys. do not follow these specification( see IMG_2) . Connections specified: Delta-delta ; connections used: wye wye Question: is it fine? as I need to simulate IEEE 123 bus dist. sys., I need not abide with this manual? or should...