Pratyush Das

Thank a lot. I followed your advice and now am able to display values in the HMI. Hopefully I shall be able to integrate the SCADA soon.

Thank you for your continuous support. I am still trying to figure out how to configure a slave port in the SCADA to establish a connection (So far I have only been running it as a master) with Qtester and I should be able to do it soon. As I understand Qtester acts as the client and I have successfully connected it with a protocol simulator acting as a server. (Screenshot attached). Can you please guide me how to display this manually fed value in the HMI ? Thanks and regards, Pratyush

Hi Ricardo, I am yet to connect the SCADA with Qtester104. However I have established connection with Qtester104 and sent data using a protocol simulator (WinnPP104) from the same machine as well as as from a remote machine. We have reasons to believe that the error is probably in the SCADA configuration and we are still looking into it. With 2 different configuration we are having 2 different error. 12:23:22 Tue Mar 12 2019 - v1.24 12:23:24 !!!!!TRY TO CONNECT! Try to connect IP: 134.106.59.25 12:23:26...

The SCADA will communicate with the devices using IEC-104 protocol. I do not know how to communicate between the SCADA and OSHMI? If both software run in the same machine, what can be the communication options? Do I need to save the data in a file or database and fetch it through OSHMI for displaying ? Pratyush

Hi all, I am new to this field and this might sound too stupid but here goes. 1. With a different SCADA siftware i have managed to connect a few PLCs, RTUs etc and fetched data from them. (substations data) 2. I now want to show these data onto an HMI created by OSHMI. As a very simple case I want to do the following: Create simple text field data in inkscape. Create a new Tag in the point_list (having difficulty editing it using the .xlsm file) Somehow associate the point number with a device ip...