Matus

Thanks a lot, I will try it.

Hello, I want execute a command, but it don´t want to work, so I am asking for your help. I found some older instructions, but they don´t work for me. In extensions_custom.conf i have: [led-off] exten => s,1,Answer exten => s,n,System(sudo python /test/test.py) It´s simple code which turn on and off one LED. I also created in Custom Destinaton this target led-off,s,1 , And in Misc Application I chosed it and enabled it. And also I assigned a number. So I want to ask you if is possible even run command...

Hello, I want execute a command, but it don´t want to work, so I am asking for your help. I found some older instructions, but they don´t work for me. In extensions_custom.conf i have: [led-off] exten => s,1,Answer exten => s,n,System(sudo python /test/test.py) It´s simple code which turn on and off one LED. I also created in Custom Destinaton this target led-off,s,1 , And in Misc Application I chosed it and enabled it. And also I assigned a number. So I want to ask you if is possible even run command...

Hello, i was trying to connect MCP23017 to my raspberry pi 3, but it´s not working. When i use gpio load i2c, it says that it can´t load i2c module from kernel. I have allowed I2C in raspi-config, and i can see MCP23017 with i2cdetect. So I just want to ask if I am doing something wrong, or I2C doesn ´t work on this system. (For now I am just trying to light LED.)

After fresh installation of version from 10.10.2017 I have 452MB written after 24 hours. I just installed no-ip and added two extensions, that´s all.

Uh, I just changed router, and it´s working really well, so I think my old router is going to die.. But still that writing was weird...

In top it seems to be okay, but in iostat i have 4 times larger numbers. On older system, which i didn´t update i have read about 200 and write about 80, but in the new version I have about 600 read and 300 write. Hardware is not problem, I tried older system and it was fast on each card.

It seems like only GUI, but sometimes when i want to load something in GUI, like Dashboard, and i tried to install something via ssh, ssh is overdue. It´s like GUI load a lot of data from SD card.