Jesus Gonzalez

Thanks for your answer DonC, I have checked input and output device settings and both are set to 48kHz sample rate. But also I have seen that the box "Allow APPs to take exclusive control of this device" was unchecked (Off). Then I have ticked the box (On) and now it works Thank you very much again Jesus

Hi all, I am trying to use Zoom recorder H4n Pro as a mic through its own driver: "Zoom H & F Series ASIO" but when I try to connect to a Jamulus Server I receive the following message: "Your sound card is not working properly. Please open you settings window and check the Device selection and the Driver settings". However if I use ASIO4All instead, my H4n Pro works fine. Any idea how to work it out? Thanks in advance Jesús BTW. I am using W10 64 bits, and Jamulus 3.6.2 and Zoom H & F Series Audio...

Hi all, I am trying to use Zoom recorder H4n Pro as a mic through its own driver: "Zoom H & F Series ASIO" but when I try to connect to a Jamulus Server I receive the following message: "Your sound card is not working properly. Please open you settings window and check the Device selection and the Driver settings". However if I use ASIO4All instead, my H4n Pro works fine. Any idea how to work it out? Thanks in advance Jesús

When she disconnected her Wifi her Ethernet cable was not properly connected to the router and then she got a public IP address, not a private one. She has right connected the Ethernet cable to the router and now it works.

Hi, I am in a choir where most of team members have installed already Jamulus successfully. But the last one, she cannot see the list of Jamulus public servers and, what is worse, she cannot connect to my private Jamulus server, got the message "Trying to connect". We have deactivated Windows Firewall with no success. She is running W10 Home with 64 bits Any help will be welcome Jesus Gonzalez

Thanks Gilgongo for your answer. At the end I have ticked out SplitCam Audio Mixer device on ASIO4all config so I have left as active only the Realtek device and now it works. Thank you again

Hi All, I have installed ASIO4all and Jamulus and received an error msg: "No usable ASIO audio device (driver) found" , "ASIO4ALL v2:The audio device does not suppport the required sample rate. The required Sample rate is 48000 Hz." Here attached the error msg and also the ASIO4all configuration. I've ticked on Always Resample 44.1 kHz to 48 kHz with no success. Any help will be welcome Thanks in advance Jesus Gonzalez

Hello, I have similar problems as mentioned before. The same message as Helmut . "No usable ASIO audio device (driver) found" , "ASIO4ALL v2:The audio device does not suppport the required sample rate. The required Sample rate is 48000 Hz." Here attached the error msg and also the ASIO4all configuration. I've ticked on Always Resample 44.1 kHz to 48 kHz with no success. Any idea will be welcome Thanks in advance