Jberg

Thanks to Jerry, Anobium for raising new details Have to go with PIC18F27Q43 series To confirm any suspicions I asked AI again about 18F14K22 I2C speed and here's AI response: If AI is 'right on'

Thanks to Jerry, Anobium for raising new details Have to go with PIC18F27Q43 series To confirm any suspicions I asked AI again about 18F14K22 I2C speed and here's AI response: If AI is 'right on'

Thanks to Jerry, Anobium for raising new details To confirm any suspicions I asked AI again about 18F14K22 I2C speed and here's AI response: If AI is 'right on'

Thanks to Jerry, Anobium for raising new details To confirm any suspicions I asked AI again about 18F14K22 I2C speed and here's AI response:

Thanks to Jerry, Anobium for raising new details To confirm any suspicions I asked AI again about 18F14K22 I2C speed and here's AI response:

I'll give it a try. Thanks, for the inside.

Basicaly the project use Holtek HT9032D FSK, a 24FC256 EEPROM + PIC18F14K22 at 64 Mhz if the make sense then I'll setup the parts on PCB, and start experimenting AI suggestion: (GCBASIC Code with 24FC256 1 MHz I2C Integration) '--------------------------------------------------------------------- ' GCBASIC Caller ID Whitelist via High-Speed 24FC256 EEPROM (PIC18F14K22) '--------------------------------------------------------------------- #chip 18F14K22, 64 ' Run PIC at 64 MHz max internal clock...

Hello, Can this work, a 24FC256 EEPROM + PIC18F14K22 at 64 Mhz an the i2c set at 1 Mhz to read EEPROM records ? Here's what AI replied for the I2C setup. ' Configure High-Speed Hardware I2C Master Mode ' For PIC18F14K22: SCL is Pin 11 (RB6), SDA is Pin 10 (RB4) ' #define HI2C_BAUD_RATE 1000 ' Set I2C bus speed to Ultra-Fast Mode (1 MHz / 1000 kHz) ' #define HI2C_DATA PORTB.4 ' #define HI2C_CLOCK PORTB.6 HI2CMode Master Thanks for any advices