franta

After some search, it seems as a temporary crutch, changing CFLAGS during configure can be used: %configure CFLAGS="%{optflags} -Wno-implicit-int -Wno-int-conversion" (in my case, change is in RPM packager xoscope.spec file)

comedi_get_cmd_generic_timed configure test failed

IMO the patch only addresses the logging effect, not the cause. According to the snmpd man page, by default snmpd listen on all IPv4 interfaces. Also, it should be possible to specify IPv4 listening address via transport specifier (thus perhaps is no need for some -4 / -6 cmdline switches which are usually seen on other multi-protocol apps) - and in this case "/proc/net/if_inet6" should be never opened. Maybe NETSNMP_ACCESS_IPADDRESS_LOAD_IPV4_ONLY bit should be set in "load_flags" and isn't ?

examples wiki pages does not exists

Cannot it be same problem as with bug #540 ? When yes, then it should be already...

Hi Stas, thanks for all Your advices. Revised patch is attached. Regarding to cmdline...

One thing which I not understand are these debug output redefinitions. When pick...

longer fs patch listing in debug log