Steve Scott

Changed my mind - going to roll my own using a Wiznet W5100S-L and a LPJD0110BANL transformer ethernet connector.

I have ordered 2 of the WIZ750SR-TTL: TTL Version from Mouser and will attempt to get 2 boards to send/receive data between them.

Thanks Evan, I will look into it. I have used USR-TCP232-T2 in another project for UDP exploration however, this module looks to be better - I think.

I may buy a module from Mouser (950-WIZ750SR-105 for $25 US) and start poking around with it - features below: Serial to Ethernet Module based on W7500P MCU Software and Hardware compatible with WIZ107/108SR S2E Module The modules is available in three versions: WIZ750SR-TTL: TTL Version WIZ750SR-RS232: RS-232 Version WIZ750SR-RS485: RS-485/422 Version 10/100Mbps Ethernet & Up to 230kbps serial speed Pin-header(2x6) type & RJ-45 connector mounted module 4-Pins Configurable User's I/O Status pins:...

OK Evan, what would be your suggestion? Would like both wired and wireless modules if at all possible. Looks like the WIZ750SR might work well - wired ethernet. Regards.

OK Evan, what would be your suggestion? Would like both wired and wireless modules if at all possible. Regards.

Anybody using this as an easy way to do Ethernet? It can: Support Hardwired Internet protocols : TCP, UDP, WOL over UDP, ICMP, IGMPv1/v2, IPv4, ARP, PPPoE Support 4 independent SOCKETs simultaneously Supports half/full duplex operation Support SOCKET-less command ARP-Request, PING-Request Support Ethernet Power down mode & Main Clock gating for power save Support Wake on LAN over UDP Supports high speed SPI Interface (SPI mode 0/3), Parallel System Bus with 2 Address signal & 8bit Data Internal 16Kbytes...

Apologies, I did not copy the image correctly - did not come across.