Durga Aryal

It was around 0.7. I got you, I read the manual and found how OpenDSS works. Thank you very much Roger.

You are right. Although I defined the resistance explicitly to zero, the sources were not sending the total power of 2 GW. But now setting vminpu to zero in load, everything is fine. Thank you so much Roger, I really appreciate your help.

I am sorry, it was reactance. The resistance for the circuit is zero. You are right if I lower the load value everything is fine. The problem was because of low voltage at load due to heavy loading condition.

Since there are two sources in the circuit, so at first I tried to build the circuit considering generator as one source but later I found that we can put more than one voltage source, after reading the forum. Then I commented out the generator and kept another source in the circuit. . The resistance for the circuit is 0.17424 ohms, so I didnot define length as default value is one and resistance is ohms per unit length so finally it will give the resistance 0.17424 Ohms. No it is just the test case,...

Hi everyone, I was trying to build the ciruit with loop in OpenDSS as given below. The circuit has two sources in it, the problem is that I am using the load that draws 2 GW power but the sources are giving total of 1.6 GW power. Can you please see my circuit and tell me where is the problem? ! OPENDSS CIRCUIT 1 clear !Slack bus New object=circuit.Ckt1 ~ basekv=13.2 pu=1.0 phases = 3 Isc3 = 30000000000 Isc1=10000000 bus1=bus1 new Vsource.source2 basekv=13.2 pu=1.0 phases =3 Isc3 = 30000000000 Isc1=10000000...

That means if we do set totaltime = 0, then it will give the time to run a circuit for a single time? But I did not find huge difference setting a totaltime to zero.

Thank you Davis, the thing that is making me confused is, when we are doing time-series that means solving the same circuit for suppose 65 loading conditions, then total time will give the time for solving that circuit 65 times or just a single time?

Hi everyone, In case of time-series simulation when I do 'get totaltime', OpenDSS will give me the time. I am confused that ,it is the time for just the last run or the total time to run whole time-series? Please help!! Thank you, Durga