Re: [zd1211-devs] zd1211rw couldn't load firmware. Error number -145 with Kernel 2.6.30

[Mladen H. <aci...@op...>]

Hin-Tak Leung <hintak_leung <at> yahoo.co.uk> writes:

> 
> -145 is time out ('Use the source, Luke!'). mips is a bit exotic, not many
people have that, and probably not
> very well-tested; could try compat-wireless to see if there is any endian
fixes. The other thing is, ohci
> is a bit slow, and the ZyDAS chip draws a fair amount of power and doesn't
really work on bus-powered usb 1.1
> host, if that's what you have. I don't know if you would get a 'not enough
power' message - I seem to recall I
> did. 
> 


Hi Hin-Tak

thanks for your fast answer.

The same stb only booted with a rt73usb wlan stick attached has no
problems with the firmware upload and also wpa-supplicant connection and
everything works on wlan0.  only problem are these two zd1211b usb sticks in the
zd1211rw driver i have here.

the same stb running a kernel 2.6.12 and the original vendor driver 2.22.00
works without problems..

i will take a look what happens with an externally powered usb hub.

Hope this helps. 
If any other logs are needed i will provide them.

Regards

Mladen