Interlacing port trace?

[Paul Nederveen]

Mattias,

Apologies if this has been asked and I could not find the answer.

I have a situation where I must put individual FTDI sniffers in Rx mode on a bus between an MCU and component. I open two terminals to watch them. Is there any way / feature that could blend or interlace those into one log stream?

MCU Tx watch
(17:03:31.455) AT+QNWINFO
(17:03:31.583) AT+GSN
(17:03:32.334) AT+QIACT=1
(17:06:02.374) AT+QIACT=1
(17:06:02.438) AT+QIACT=1

MCU Rx watch
(17:03:31.469) +QNWINFO: "EDGE","310260","GSM 1900",560
(17:03:31.529)
(17:03:31.529) OK
(17:03:31.597)
(17:03:31.597) 864351055609616
(17:03:31.659)
(17:03:31.659) OK
(17:06:02.359)
(17:06:02.359) ERROR
(17:06:02.396)
(17:06:02.396) ERROR
(17:06:02.437)
(17:06:02.437) ERROR

Thank you!
Paul

[Maettu]

Hi Paul,

It's not yet available, but discussed here and will eventually be implemented in FR #288 "serial COM sniffer functionality".

Best regards,
Matthias