[xcat-user] MAC messages flood when using winstall

[gvijeeth at gmail.c. (V. Reddy)]

Hi,

Below is the output when I try to install using winstall. Can anyone
pls advice whats going wrong with DHCP or MAC?


eth0: Broadcom BCM5701 Integrated Copper transceiver found
eth0: Scatter-gather ON, 64-bit DMA ON, Tx Checksum ON, Rx Checksum
ON, 802.1Q VLAN ON
eth1: Broadcom BCM5704 1000Base-T found at mem fc030000, IRQ 7, node
addr 000d601460ad
eth1: Broadcom BCM5704 Integrated Copper transceiver found
eth1: Scatter-gather ON, 64-bit DMA ON, Tx Checksum ON, Rx Checksum
ON, 802.1Q VLAN ON
DHCP attempt on eth0
bcm5700: eth0 NIC Link is UP, 1000 Mbps full duplex, receive &
transmit flow control ON
bcm5700: eth1 NIC Link is UP, 1000 Mbps full duplex
MAC-00:0D:60:14:60:AC-MAC
ALLMACSTART
mac:eth1-00:0D:60:14:60:AD-eth1:mac
ALLMACEND
PING 172.20.237.1 (172.20.237.1) from 172.20.237.15 : 56(84) bytes of data.
64 bytes from 172.20.237.1: icmp_seq=1 ttl=64 time=0.383 ms

--- 172.20.237.1 ping statistics ---
1 packets transmitted, 1 received, 0% loss, time 0ms
rtt min/avg/max/mdev = 0.383/0.383/0.383/0.000 ms
MAC-00:0D:60:14:60:AC-MAC
ALLMACSTART
mac:eth1-00:0D:60:14:60:AD-eth1:mac
ALLMACEND
MAC-00:0D:60:14:60:AC-MAC
ALLMACSTART
mac:eth1-00:0D:60:14:60:AD-eth1:mac
ALLMACEND
MAC-00:0D:60:14:60:AC-MAC
ALLMACSTART
mac:eth1-00:0D:60:14:60:AD-eth1:mac
ALLMACEND
PING 172.20.237.1 (172.20.237.1) from 172.20.237.15 : 56(84) bytes of data.
64 bytes from 172.20.237.1: icmp_seq=1 ttl=64 time=0.214 ms


Thanks,
Vijeeth