After much turmoil (wont go into that), was finally able to transfer my X-11 basic program to the HD 10, but with surprising results. The smartphone sized display came up as expected, in the upper left side, and the top row of selection buttons seemed to work as they did on my phone. However, as I go down the other 4 rows of buttons, it appears that the cursor that appears when I select a button, moves further and further down away from where I press, and the appropriate buttons do not get selected. I haven't loked into this yet, and have no idea where to start In the 5th row of buttons, I can select them by pressing about 1 inch below them, and to EXIT, the button being at the bottom right, I have to go off the phone-sized screen and approximately 2 inches below. I was wondering if anyone had seen this before, and might be able to help me figure out how to fix it.
Thanks, if there is anyone who can help.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
After much turmoil (wont go into that), was finally able to transfer my X-11 basic program to the HD 10, but with surprising results. The smartphone sized display came up as expected, in the upper left side, and the top row of selection buttons seemed to work as they did on my phone. However, as I go down the other 4 rows of buttons, it appears that the cursor that appears when I select a button, moves further and further down away from where I press, and the appropriate buttons do not get selected. I haven't loked into this yet, and have no idea where to start In the 5th row of buttons, I can select them by pressing about 1 inch below them, and to EXIT, the button being at the bottom right, I have to go off the phone-sized screen and approximately 2 inches below. I was wondering if anyone had seen this before, and might be able to help me figure out how to fix it.
Thanks, if there is anyone who can help.