[wsjt-devel] F/H stops calling after 5 cycles

[K2DBK-WSJT <k2d...@k2...>]

I've noticed that in F/H mode after I call 5 times Enable Tx will turn off,
similar to what happens in non F/H mode when the Tx watchdog expires.
However, unlike in that case, there's no red indicator in the lower left
corner, it just stops sending. I've confirmed that my watchdog timer is set
higher than that (just in case) and it's set to 6 minutes. The number of
cycles seems to be consistent, and I've got no issue in other modes, ruling
out something like RF causing an issue. I've looked through the
documentation and couldn't find any reference to maximum number of calls
before it will stop on its own.  I'm not transmitting on top of the Fox,
I've seen this both with and without "Rx All Freqs" set. One thing I've
noticed is that just before Enable Tx turns off, the Decode button will
flicker very briefly, something I don't see at any other time. Also, even
though it seems to be on the 5th transmit cycle, it looks like sometimes the
Enable Tx button will turn off just as a transmission is starting, and
sometimes immediately after it's finished. I'm baffled.

 

I'm running v2.1.0 on Windows 10 1903 build 18362. I've got Save All checked
in case those files would be of any use in diagnosing this.

 

73,

David, K2DBK