Re: [wsjt-devel] "Invalid QSO Data" when trying to log during mock contest - RC7

[K2DBK-WSJT <k2d...@k2...>]

I didn't see any comments from anyone on the development team about this. I
checked the Known Issues and it's not marked there either. I read Joe's note
that issues identified are being corrected for the GA release and I wanted
to know if this issue had been addressed?

 

From: K2DBK-WSJT <k2d...@k2...> 
Sent: Tuesday, June 4, 2019 7:52 PM
To: 'WSJT software development' <wsj...@li...>
Subject: [wsjt-devel] "Invalid QSO Data" when trying to log during mock
contest - RC7

 

I was making a few contacts in the mock contest this afternoon and ran in a
problem where to an issue where the QSO completed but when I tried to log it
a dialog popped up that said "Invalid QSO Data  Check exchange sent and
received". I've attached a screenshot of what was going on at the time. The
Rpt Sent & Rcvd fields were initially populated corrected but  are blank now
as I think this was my 2nd or 3rd attempt to fill in and log. To finally get
it to log I hit Cancel on the logging window then clicked on Log QSO, filled
in the same information as before, and it went through. 

 

This happened a second time in the exact same way, and one thing that I
noticed that was the same (although unfortunately I don't have a screenshot)
is that there was another signal decoded in the Rx Frequency window between
my report to the other station and his RR73 to me. I don't know if that's
related but I wanted to mention it.

 

I do have Save All decodes checked so I can provide those if it will help.
I'll continue to see if I can see this again. This is on Window 10 Pro
64-bit running the 64-bit version of WSJT-X.