Menu
▾
▴
Re: [webmin-l] [bug report] webmin gui - binding webmin to non-public lo ip fails
|
From: Jamie C. <jca...@we...> - 2018-06-10 18:08:41
|
On 10/Jun/2018 10:51 ѽ҉ᶬḳ℠ <vt...@gm...> wrote .. > > > I'm surprising that having non-local IPs on the "lo" interface works .. but > > even so, Webmin should allow this. > > > > If you go to Hardware -> Network Configuration -> Network Interfaces, does > > that IP show up? > > The additional lo ips do not show on Active Now, only the last > additional ip (172.23.124.98) is showing at Activated at Boot. > > The system is running iproute2 and ifupdown2, ifupdown is removed. lo > config: > > iface lo inet loopback > address 172.23.120.98/32 > address 172.23.121.98/32 > address 172.23.122.98/32 > address 172.23.123.98/32 > address 172.23.124.98/32 > > Output from -> ip a ls lo: > > 1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN > group default qlen 1000 > link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00 > inet 127.0.0.1/8 scope host lo > valid_lft forever preferred_lft forever > inet 172.23.120.98/32 scope global lo > valid_lft forever preferred_lft forever > inet 172.23.121.98/32 scope global lo > valid_lft forever preferred_lft forever > inet 172.23.122.98/32 scope global lo > valid_lft forever preferred_lft forever > inet 172.23.123.98/32 scope global lo > valid_lft forever preferred_lft forever > inet 172.23.124.98/32 scope global lo > valid_lft forever preferred_lft forever What output do you get if you run "ip addr" or "ifconfig -a" |
