Re: [webmin-l] [bug report] webmin gui - binding webmin to non-public lo ip fails

[ѽ҉ᶬḳ℠ <vt...@gm...>]

> I'm surprising that having non-local IPs on the "lo" interface works .. but
> even so, Webmin should allow this.
>
> If you go to Hardware -> Network Configuration -> Network Interfaces, does
> that IP show up?

The additional lo ips do not show on Active Now, only the last
additional ip (172.23.124.98) is showing at Activated at Boot.

The system is running iproute2 and ifupdown2, ifupdown is removed. lo
config:

iface lo inet loopback
    address 172.23.120.98/32
    address 172.23.121.98/32
    address 172.23.122.98/32
    address 172.23.123.98/32
    address 172.23.124.98/32

Output from -> ip a ls lo:

1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN
group default qlen 1000
    link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
    inet 127.0.0.1/8 scope host lo
       valid_lft forever preferred_lft forever
    inet 172.23.120.98/32 scope global lo
       valid_lft forever preferred_lft forever
    inet 172.23.121.98/32 scope global lo
       valid_lft forever preferred_lft forever
    inet 172.23.122.98/32 scope global lo
       valid_lft forever preferred_lft forever
    inet 172.23.123.98/32 scope global lo
       valid_lft forever preferred_lft forever
    inet 172.23.124.98/32 scope global lo
       valid_lft forever preferred_lft forever