[vmtk-users] Fwd: Centerline Tracing of a loop
Brought to you by:
davidsteinman,
lucantiga
From: Leong Y. S. <leo...@gm...> - 2013-02-22 12:10:25
|
---------- Forwarded message ---------- From: Leong Yong Shin <leo...@gm...> Date: Fri, Feb 22, 2013 at 7:01 PM Subject: Centerline Tracing of a loop To: vmt...@li... Dear vmtk-users, I am using VMTK on 3D slicer and I have encountered a problem. I have a model which is a solid straight line with a open loop in the middle. I wanted to trace the centerline of the loop, however, the VMTK centerline module can only trace the centerline of a single branch (of the loop). (FYI: the seed and the target fiducials are at both ends of the straight line). I have attached an image of my result in the mail for illustration. What I wish to achieve: The tracing of the entire loop with a single seed and a single target point. The centerline must branch at the bifurcation and rejoin at the opposite end of the loop. Is there anyway to achieve this? Any help is deeply appreciated. Thanks! Take Care! *Leong Yong Shin* * * -- Take Care! *Leong Yong Shin* * School of Chemical & Biomedical Engineering * |