It has been 6 months since downloading above. I put it on a Memorex 3.1 128gb flash drive. It works fine and I have yet to forget my password. I still same Veracrypt I downloaded on my windows 10 home but never use it. Nothing on my Windows 10 is Veracrypted. I purchased a new 128gb San Disk USB 3.1 but when I go to open Veracrypt on my laptop i get below attachment. When I download from SourceForge same problem.
What am I doing wrong?
No answer to above. So I tried again ignoring all options in above image. Guess what?
Veracrypt downloaded to my D:\ drive.
Now another question. I have 35gb used and 22gb free on on flash drive . Can I create a 20gb partition, then transfer 20gm from 35gb leaving 15 free. then stretch out or add partition to first 20gb for whatever is left on flash drive and transfer remain 15gb to it and have whatever number of gb's free to use as encrypted?
Thanks
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
If the first part (low memory addresses) of your UFD contains 35GB of "used" space, and the later/higher-memory part contains 20GB of free space where you plan to put your VC partition, then the answer is NO! You can only expand a partition into later/higher-memory spaces; you cannot expand downward into lower-memory spaces.
However, if you have a lot of free space at the start (low memory addresses) of your UFD, you can put your VC partition there, then erase the high-memory partition. That will allow you to use the VC-Expansion Tool to enlarge your encrypted partition into that higher memory space.
(Of course, over the past few days, you may have already figured this out.)
-- RadMan
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
It has been 6 months since downloading above. I put it on a Memorex 3.1 128gb flash drive. It works fine and I have yet to forget my password. I still same Veracrypt I downloaded on my windows 10 home but never use it. Nothing on my Windows 10 is Veracrypted. I purchased a new 128gb San Disk USB 3.1 but when I go to open Veracrypt on my laptop i get below attachment. When I download from SourceForge same problem.
What am I doing wrong?
No answer to above. So I tried again ignoring all options in above image. Guess what?
Veracrypt downloaded to my D:\ drive.
Now another question. I have 35gb used and 22gb free on on flash drive . Can I create a 20gb partition, then transfer 20gm from 35gb leaving 15 free. then stretch out or add partition to first 20gb for whatever is left on flash drive and transfer remain 15gb to it and have whatever number of gb's free to use as encrypted?
Thanks
No answer to above!
Sure, I have an answer . . .
"It depends!"
If the first part (low memory addresses) of your UFD contains 35GB of "used" space, and the later/higher-memory part contains 20GB of free space where you plan to put your VC partition, then the answer is NO! You can only expand a partition into later/higher-memory spaces; you cannot expand downward into lower-memory spaces.
However, if you have a lot of free space at the start (low memory addresses) of your UFD, you can put your VC partition there, then erase the high-memory partition. That will allow you to use the VC-Expansion Tool to enlarge your encrypted partition into that higher memory space.
(Of course, over the past few days, you may have already figured this out.)
-- RadMan