RE: [Vacm-develop] BMC upgrade

[San M. <net...@va...>]

Hmm... sounds like the upgrade toasted... contact your intel
representative for the special 'bios recovery floppy' and instructions
on how to recover your toasted bios
-san


-----Original Message-----
From: vac...@li...
[mailto:vac...@li...] On Behalf Of Martin,
St=E9phane
Sent: Thursday, September 13, 2001 11:56 AM
To: vac...@li...
Subject: [Vacm-develop] BMC upgrade

Hi,
	I want to run VACM on an Intel L440GX+.  I have tried to upgrade
the
BMC firmware on the motherboard from 0.9? to 1.14 as stated on the VACM
Users and Programmers Manual (section 5.2.27).  The upgrade seems to run
correctly, however it freezes at the end and now there is no more
activity
on the motherboard.  Even the BIOS doesn't start.  The whole setup was
running perfectly with Red-Hat 6.2 prior the upgrade.  Does anyone
enconter
this problem and did you find a solution?=20

------------------------------------------------------------------------
----
---------
Stephane Martin, ing.                                  Kontron
Communications
Low Level Software Engineer                       616 Cure-Boivin
Tel (450) 437-4661 ext: 2349                       Boisbriand, Quebec
Fax (450) 437-8053                                    Canada, J7G 2A7
mailto:ste...@ca...       http://www.teknor.com



_______________________________________________
Vacm-develop mailing list
Vac...@li...
https://lists.sourceforge.net/lists/listinfo/vacm-develop