Re: [Unichrome] XVIDEO problems - video not filling window
Brought to you by:
dwdeath
From: Luc V. <li...@sk...> - 2006-07-17 16:39:55
|
On Mon, Jul 17, 2006 at 04:12:24PM +0100, Barry Scott wrote: > I'm running the lastest git sources against Xorg 7.1 built for FC4 > running kernel 2.6.17.1 with its DRM. > > Xine is first playing v4l:/Composite0 and I see the TV capture > filling the xine window. Next xine plays the start of an mpeg2. > > When the mpeg2 movie is playing it is not filling the window. > The movie fills the height but only fills about 80% of the width. > The remaining 20% shows a flicker image that is part of the previous > v4L:/Composite capture. > > Next the v4l:/Compoite0 capture is played again. This time > it fills the width but only about 80% of the height. The bottom > 20% shows a flickering image that is from the end of the first > captured material played. > > Attached is the config file and the log with -logverbose 8 > inside the .tar.bz2 > > The one thing that jumps out at me from the log is these > warnings: > > (WW) VIA(0): ViaHQVSwovIdle: Video3 still firing. > > I tried increasing the loop count from 10 to 1000 but the > warnings still appear. This would seem to indicate the > CLE266 is in a bad state. > > Barry Are you certain that played videos are: YV12: 640x480 YV12: 480x576 The latter seems an odd resolution. The blame does point to the video engine not idling properly. The flashing is caused by Video3 still trying to display with its old values, and thus, one in three frames or so are displaying fb content that wasn't written to since the 640x480 video, the other 2 should be older content from the current stream (in the wrong position). This could be another or the same VT3122C issue, i'm now going to confirm this by testing both VT3122A and VT7205A. Luc Verhaegen. |