Sorry to be a bore but I'm having trouble getting Trinux to install properly
on my laptop.
I'm using the pcmcia floppy image and my network card is a D-Link DE660, it
works fine with my installation of Mandrake that's on my laptop.
I've put on the boot floppy pcmcia-pcnet.tgz. I modified this by adding
'8390.o' to it as this seems to be required.
however, at boot up my card is not installed properly. it beeps with a high
pitch and then beeps with a low pitch and says eth0 is not installed. below
is a bit of detail from the bootup message:
installing base packages from /floppy
cardmgr[147] initialising socket 0
cardmgr[147] socket 0: D-Link DE660 Ethernet
cardmgr[147] executing /insmod/lib/modules/2.4.5/net/8390.o
cardmgr[147] executing /insmod/lib/modules/2.4.5/pcmcia/pcnet_cs.o
cardmgr[147] insmod exited with status 139
cardmgr[147] executing modprobe pcnet_cs
cardmgr[147] modprobe exited with status 2
cardmgr[147] get dev info on socket 0 failed: Resource temporarily
unavailable
Any ideas/suggestions gratefully received.
Ed
|
