Fw: [Trinux-talk] Cannot Configure Nic NE2000

[Carlos A. A. <ca...@cd...>]

Hello Helmut:
Thank you very much for your soon answer

>> I added in /tux/config/modules following lines:
>> 8390.o
>> ne.o io=0x240

>Which IRQ does the card use? Maybe you have to set it to "ISA" or
>"legacy" in the CMOS setup.

The card is in IRQ=10
If I do:
# insmod ne io=0x240 it shows up in lsmod and in
        /proc/interrupts
        /proc/ioports

>What tells
>       ifconfig eth0 192.168.0.21 up
>
>       ifconfig

If I do this by hand it shows OK and works, but how or where should I put
this information for it to come up automatically at boot.-

I am using the last Version of Trinux 0.890.-

Awaiting and Best Regards
Carlos