[Trinux-talk] Re: RE:Kernel for Adaptec

[Richard T. <ri...@th...>]

Hello again,

The reason I need read-only access to the NTFS partition is so I can =
create a bit-copy of the partition for forensic analysis. I want to use =
dd to create the bit-copy. So, how do I get the kernel that supports =
Adaptec into a boot.img file that I can burn to CD? I am assuming that =
once I do this, the packages will load properly from the SCSI CD drive =
during the boot process. Is this correct? I hope this isn't a really bad =
newbie question. Thanks.

Rich Thomas
  ----- Original Message -----=20
  From: Richard Thomas=20
  To: tri...@li...=20
  Sent: Tuesday, November 27, 2001 4:27 PM
  Subject: RE:Kernel for Adaptec


  Hello All,

  I need some clarification. Matt built a kernel with Adaptec SCSI =
support. Do I need to put the bzImage file on the CD that I want to boot =
from? I put it on a floppy and tried to boot from it with the current CD =
in the drive, but that did not work as planned. What I am trying to do =
is gain read-only access to the NTFS partition. The CD drive is on an =
Adaptec AIC-7860 controller. The NTFS partition is on a Dell PowerEdge =
Expandable RAID 2 controller. Any suggestions? Thanks.

  Rich Thomas